![]() It’s the resistance to change when there’s an alternating current. The concept of resisting current flow show be pretty easy to imagine even if you have no concept of electricity at all. ![]() 78.9mb Impedanceīefore we start there’s a concept that needs to be clarified or some of the side-effects that we see happening later won’t make any sense.Įlectrical impedance, not the software development type (which is surprisingly similar!)Įlectrical resistance is pretty easy to grok. ![]() These are the test results for the Frequency and part of the Distortion sections. Here’s the REW test files for use with REW. These are the results for the Distortion sections. Here’s the CSF files for use with Voxengo Span Plus. I’m using an old (and reliable) Radioshack SPL meter. I will be primarily using MNoiseGenerator with pink noise then REW and Span Plus for signal measurements. Fender Hotrod Deville 410 that’s been heavily modified.The following pieces of equipment will be used for demonstration: Pad - A circuit that reduces the signal level.Reamp - A box specifically made to convert an line level signal to something that can be sent to a guitar amp.H-pad + pad means that I use the the H-Pad cable along with the Pad on the Radial JDI direct box.I will be using an H-pad with 4 resistors of 270Ω and a single 47Ω resistor.H-pad - A resistor network built into the cable to reduce the signal level.Reamp with a direct box? What’s the problem?.There’s also another 97.4mb of optional downloads. This post will load up to 105mb of data!!! Let’s find out with some measurements and then real world tests. What IS Reamping? What are these things you do it with? Why do you use them? And can you really do that? There’s all sorts of arguments on the internet on whether you can use a Passive DI in reverse as a Reamp, or go straight out of your amp or maybe use a special cable?
0 Comments
Leave a Reply. |